• Metal cans

    Metal cans

Coating of metals

Chemical interface measurements for protection, painting and bonding

The majority of metals produced throughout the world are painted, bonded or provided with a protective coating when they are processed. Our tensiometers and contact angle measuring instruments check the wetting and adhesion of the coating materials involved, thus enabling high product quality to be achieved and processes to be optimised.

Typical metal-coating applications

Wetting and adhesion between coatings

Paints and adhesives, particularly those which are water-based, frequently have to be adjusted for contact with the metal surface. Our measuring instruments determine the surface free energy and polarity of the metal and the surface tension of the coating material.
Important information is obtained by combining the results: 

Quality assurance of the surface protection

It must not be possible for painted coatings and corrosion protection of the metal surface to be wetted by potentially aggressive liquids such as water or saline solutions. The contact angle is therefore a direct measure of the effectiveness of the protection.

Checking the surface pre-treatment

Coating is usually preceded by pre-treatment of the metal. The objective of this is to increase the surface free energy which is reduced by contamination or passivation of the metal.

Effective and uniform pre-treatment leads to uniform, good wettability and high surface free energy. These measurements can be checked using our mobile contact angle measuring instrument.

Cleaning baths contain surfactants as wetting and cleaning agents. The surface tension is measured in order to check their effectiveness and efficiency. The active ingredient content of a bath containing surfactants can be checked on site using our mobile Bubble Pressure Tensiometer – BPT Mobile.

KRÜSS Application Reports

AR286: Determine how clean surfaces are: Quickly and on the go

Surfaces need to be cleaned until they have reached the necessary degree of cleanliness – and not longer. But how can the cleanliness of a surface be measured reliably? We cleaned steel plates of varying lengths in an ultrasonic bath and determined the respective surface free energies. What can't be seen by the naked eye was able to be made visible in this way.

AR243: Choosing a corrosion prevention compound - surface science helping to preserve aeronautical equipment

The wetting of five anti-corrosion oils for the aircraft industry is investigated for pre-corroded, dry and wet aluminum. Calculated wetting and re-wetting energies correlate with the actual wetting determined in the investigation.